Cpt Sim C-130 problem
Posted: 14 May 2008, 12:05
Hey Guys,
I bought the Cpt Sim C-130 for FS9 from Just Flight a month or so ago and have had a few very enjoyable flights when using ye olde 'warm start on the active runway' approach.
However, I felt it was time I started learning the ins and outs of this fantastic aircraft and run through the tutorials - both the Just Flight Lyneham circuit one and the one by Bernardo Srulzon at FSStation.
Everything went well with engine start-up (if a little dizzy after searching for relevant switches/buttons/meters
) as far as changing the frequencies on the NAV radios. It won't happen - i.e. the frequencies are 'stuck' on the ones that are set when the units are first switched on. As with normal default FS radios, you can use either clicking on the display numbers or the dial to change the frequencies, but nothing is happening.
I hear the clicks from the cockpit sound, but nothing happens. I also can't swap the primary and secondary frequencies. On my previous 'hot-start' jaunts, I didn't use the radios at all.
I seem to remember having a similar problem in my early VATSIM excursions, but can't remember how I fixed it - if I knew at all.
I would ask on the JF forum but their 'support' has been sadly lacking in the past - and the Cpt Sim support is down for a month.
Any useful help gratefully appreciated.
I bought the Cpt Sim C-130 for FS9 from Just Flight a month or so ago and have had a few very enjoyable flights when using ye olde 'warm start on the active runway' approach.
However, I felt it was time I started learning the ins and outs of this fantastic aircraft and run through the tutorials - both the Just Flight Lyneham circuit one and the one by Bernardo Srulzon at FSStation.
Everything went well with engine start-up (if a little dizzy after searching for relevant switches/buttons/meters

I hear the clicks from the cockpit sound, but nothing happens. I also can't swap the primary and secondary frequencies. On my previous 'hot-start' jaunts, I didn't use the radios at all.
I seem to remember having a similar problem in my early VATSIM excursions, but can't remember how I fixed it - if I knew at all.
I would ask on the JF forum but their 'support' has been sadly lacking in the past - and the Cpt Sim support is down for a month.
Any useful help gratefully appreciated.