Hamble in GenXv3

[DaveB]

Well.. I uninstalled it (deleted from Scenery Library), added everything except the trees and reinstalled it. No change for me I'm afraid..



This shot shows the inner cliffs better. Looking at the alt when I was in the Beech on the runway.. it varied up and down around 72.3ft. I drove the Beech off the runway and dropped down to 59.1-59.3ft

Checking the readme, this was made for GenXv2.

ATB
DaveB

[TSR2]

Hi Dave,

I think the difference between yours and mine might be the mesh resolution setting in FSX, ours being slightly smoother

[DaveB]

I don't think that's it to be honest with you mate. It worked fine in FSX with GenXv2. It looks for all the world like a flatten is missing. I had exactly the same moving ES Guernsey into the new install.. runways/taxiways/aprons e t c all at one level and the rest in holes. I eventually found the problem was.. the ES installer shoved this file (EGJB_Guernsey_ARM_ALT.BGL) in Scenery\World\Scenery. Lobbed it into the new install and all was flat again. With Hamble, I can't see what's missing.. that is as far as I can see, nothing is missing. I have the same files George has. Mesh res wouldn't cause that much of a difference. I'm on 5m as is precribed by GenX and I run texture res at 60cm all the time which is higher (in theory) than it should be. Only the hi-res areas in GenXv3 are 60cm.. the rest still sits at 1 or 2m.

I've just found his Weston-on-the-Green and put that into my fresh install (dragged it from the old one and added via Scenery Library) and that, fortunately is fine as is Thorney. That Speedbird bloke hasn't sent the bombers over has he??

ATB
DaveB

[TSR2]

I bet he's warming them up. I've Portsmouth and Thorny too mate, and no problems there either. It should be easy enough to make a flatten for it, let me dig out FSX KML...

[DaveB]

OK Mate. I'm out for a few dozen beers now.. be back some time after 11

ATB
DaveB

[TSR2]

Really confused now. I've uninstalled Hamble and gone to the location with just the photo scenery and is almost completely flat!

Did a little bit of research and Smith Aerospace is still in the old Folland / HS / BAe factory. The main field is mostly untouched.

[GHD]

You definitely have another scenery Dave. If you have the same files I listed earlier, another scenery is active.

[speedbird591]

That Speedbird bloke hasn't sent the bombers over has he??

I bet he's warming them up.

I stood them down and gave the crews the weekend off. It looks like you've done the job for them

I'm sure It'll look much better when you get back from the pub, Dave. Just pour a large nightcap of scotch and reinstall FSX before bed

No don't! I was joking

Ian

[GHD]

It's the remnants of ORBX Dave

[speedbird591]

It's the remnants of ORBX Dave

Oh, don't start him off, George!

Ian