Hi all,
Is there an aircraft designer out there!! I know we have many talented ones here!!
I am turning some of my helicopters into AI, with the help of another post from this forum. It is going ok!
Could someone help me with contact points and what moves what etc??
I am trying to get the nose wheel of a Lynx up a bit, as when the helo taxi's it is going under the ground??
There are so many entries in the contact points of the cfg i don't know which one to change??
Thanks
Mark
P.S Contact me on msn if poss!!
aircraft designer out there?!
Moderators: Guru's, The Ministry
HSorry i didn't get a change to get back to you tonight... very busy with work at the mo, so having to do stuff from home.
As a general rule, don't touch the contact points. The best way to check they are correct is to go to a default airport and make sure all the wheels are on the deck.
there are more than a few airports that have the aircraft (helo or fixed wing) gear sink into the ground, and its more likely the airport scenery than the aircraft (although not always)
As a general rule, if the undercarrige is sittig right at a default airport, the problem is with the scenery.... usually the AFCAD2 is too low..
As a general rule, don't touch the contact points. The best way to check they are correct is to go to a default airport and make sure all the wheels are on the deck.
there are more than a few airports that have the aircraft (helo or fixed wing) gear sink into the ground, and its more likely the airport scenery than the aircraft (although not always)
As a general rule, if the undercarrige is sittig right at a default airport, the problem is with the scenery.... usually the AFCAD2 is too low..
Ben.
