FSUIPC7 in MSFS
Moderators: Guru's, The Ministry
FSUIPC7 in MSFS
I have managed to assign my CH yoke etc to FSUIPC7. That is all except managing to switch from internal to external view. I want to use the two red buttons on thew left arm of the yoke. I have tried assigning View Mode and Rev View Mode but it doesn't work. At the moment I can only get Internal view. Any help gratefully received.
Simon
'The trouble with the speed of light is it gets here too early in the morning!' Alfred. E. Neuman
'The trouble with the speed of light is it gets here too early in the morning!' Alfred. E. Neuman
- DaveG
- The Gurus
- Posts: 7818
- Joined: 23 Jun 2004, 18:05
- Location: in a deep, dark hole somewhere.
- Contact:
Re: FSUIPC7 in MSFS
I know when FSUIPC 7 first came out, view commands weren't supported (MSFS limitation), so they needed to still be assigned in MSFS itself. I'm not sure if that's still the case, but I assume it is. The view commands are the only thing I've got assigned directly in the sim on my Warthog, everything else is via FSUIPC.
Dave G.
Re: FSUIPC7 in MSFS
Thank you.
Simon
'The trouble with the speed of light is it gets here too early in the morning!' Alfred. E. Neuman
'The trouble with the speed of light is it gets here too early in the morning!' Alfred. E. Neuman
Re: FSUIPC7 in MSFS
Dave.
Got that sorted now thanks.
Got that sorted now thanks.
Simon
'The trouble with the speed of light is it gets here too early in the morning!' Alfred. E. Neuman
'The trouble with the speed of light is it gets here too early in the morning!' Alfred. E. Neuman