Peters Paints!

[MilesMan]

Cheers Graham. Last four paints done. I have broken my usual code and done a fictitious scheme for a Royal Canadian Navy Sea Hornet, for which I beg forgiveness! PX284 is up at Flightsim.com now, the others will be tomorrow pm.

[MilesMan]

OK, I think 20 Hornets is enough! Have just uploaded a Hunting President paint for Rob's Pembroke C54:

[Airspeed]

I've always liked the look of the Pembroke, and I like the twin Alvinides sound file.
Will have to check the hangar and see if I need any more paints. Thanks Peter!

[robcarrich]

Peter, that looks superb, you really are breathing new life into some old models.
The new Hornet paints bring it to a completely new level, just love the textures and weathering.
By coincidence I rolled the Pembroke out of retirement this very morning for a
low and slow flight around my new Netherlands scenery, just got to have that new scheme when its ready!

RobR

[FlyTexas]

Beautiful paint on the Pembroke, Peter.

Brian

[MilesMan]

Thanks Guys. The Pembroke is one of my favourites too and I got fed up with only having G-APMO to fly in civvies!
Rob I could not see the C54 on your site so you might have a few people asking for it now! I was going to ask about the Sea Prince but as the Pembroke was one of your FSDS creations I did not hold out any hope with you moving to Blender. No worries though!

Peter

[robcarrich]

Thanks Guys. The Pembroke is one of my favourites too and I got fed up with only having G-APMO to fly in civvies!
Rob I could not see the C54 on your site so you might have a few people asking for it now! I was going to ask about the Sea Prince but as the Pembroke was one of your FSDS creations I did not hold out any hope with you moving to Blender. No worries though!

Peter

I had better put C54 back up, at the double!
No Sea Prince Peter, I cant even remember how to start FSDS!

Rob

[blanston12]

Peter, that looks superb, you really are breathing new life into some old models.
The new Hornet paints bring it to a completely new level, just love the textures and weathering.
By coincidence I rolled the Pembroke out of retirement this very morning for a
low and slow flight around my new Netherlands scenery, just got to have that new scheme when its ready!

RobR

Hi Rob, I took the Pembroke out today and am reminded how much I liked it.
I did notice once tiny issue with the manifold pressure gauge in that it never reaches 15 even though the red-line is at 30.
I tested it in both FSX and P3D4 with the same behavior.

[robcarrich]

Hi Rob, I took the Pembroke out today and am reminded how much I liked it.
I did notice once tiny issue with the manifold pressure gauge in that it never reaches 15 even though the red-line is at 30.
I tested it in both FSX and P3D4 with the same behavior.

Joe, you need to find a good optician if that's the only fault you can find
I do use the term "not accurate" when describing the models on my site.
But you are quite right the reading is low.
If you go into the aircraft cfg.file in the [piston engine] section find "max_design_mp= 100" change to this value.
By the way Joe, behaviour is spelt behaviour not behavior

RobR

[Filonian]

By the way Joe, behaviour is spelt behaviour not behavior RobR

I had never realised before that this forum was also educational.


Graham