FS Tutorials

auster · Post by **auster** » 21 May 2007, 18:11

I wonder if someone could kindly point me in the right direction to any tutorials that deal with the design of brackets, fork ends, fittings, etc., preferably using FSDSV3. Thanks

DispatchDragon · Post by **DispatchDragon** » 21 May 2007, 18:23

Look directly above you in the Forum mate

there are more tutorial links than you can shake a stick at

BTW - if your going that way - I'll take a nice J1N GAIGT I think :roll:

Leif

auster · Post by **auster** » 21 May 2007, 18:25

Leif, I've been through that lot and maybe it's my eyesight but I didn't find what I am looking for. Ralph

Post by **Rick Piper** » 21 May 2007, 21:06

Hi Auster

http://www.fsplaza.com/tuto_list.html

Regards
Rick

auster · Post by **auster** » 23 May 2007, 23:19

Hello Rick, Many thanks for the link. I know that it was included in the sticky at the top of this section, mentioned also by Leif. I can just about manage to produce some brackets, cleats, fork ends, etc. but I feel that there maybe better ways than how I am doing it. Sledgehammer and walnuts come to mind.

Must pay you the highest compliments on your work. Real aircraft design was never as hard as this.

Ralph

Post by **Rick Piper** » 23 May 2007, 23:23

Hi Ralph

No problem Mate.

Sadly Graham Oxtoby (FSPlaza) guy has not been around for the last few months.

I think he had some real life stuff to sort out as he was building up a really good selection of stuff for FSDS 2 & 3 on there.

He is also one of the FSDS beta team along with about 5 others including me

Anyway no worries.
Regards
Rick