Eco Brussels

Post by **DaveB** » 18 Jan 2007, 12:13

Hi Chaps,

I discovered some time ago that my default Brussels National had gone green..

No idea where these trees have come from and only found I'd got them when testing a bit of scenery for Toby (Teamco) yonks ago. Needless to say, Toby wasn't seeing them :roll:

Any ideas??

ATB

DaveB :tab:

DanKH · Post by **DanKH** » 18 Jan 2007, 12:17

Might very well be the order in the scenery list.....

I move all my mesh-files to the bottom of the list, then land classes, and then Add-on's.

otherwise it could be a missing exclude file....

Hard to say when you don't have a "hands-on" possibility.

Post by **Trev Clark** » 18 Jan 2007, 12:21

What on earth are you flying there, Mr B

DanKH · Post by **DanKH** » 18 Jan 2007, 12:26

Fly?

Look in the lower right corner.....

Post by **DaveB** » 18 Jan 2007, 12:28

Hi Trev,

It's a little Cicare CH-7 that I often use to do the shopping in

Delightful model made by a Swedish author.. Lasse Lindh and can be found at most major outlets. Search for it either by the authors name or CH-7 Angel v2

Tks for that Dan. Odd that it only happens at this airport and in case you were wondering, I have no Belgian airport addons.. other than Toby's Teamco and that got removed in an attempt to see if the trees went with it

ATB

DaveB :tab:

DanKH · Post by **DanKH** » 18 Jan 2007, 12:39

hmm. in that case you may have some scenery (or indeed autogen) at a higher priority that your default Brussels.

One thing you could do is to pen AFCAD wait for it to load the airports, tap in the ICAO fro Brussels, and check out which bgl file it resides in (when its default it normally resides in a "24143163-kind of file" instead of an AF2_ kind of file)

If the trees you have installed lies in/ is activated in a separate directory try to move it down the hierarchy to see it it solves the problem...

Post by **Trev Clark** » 18 Jan 2007, 18:42

It's a little Cicare CH-7 that I often use to do the shopping

Thanks Dave, I thought you had put the default Robinson through the mangle! :roll:

Post by **DaveB** » 18 Jan 2007, 20:28

No chance of me flying that piece of poo Trev

I checked the number of files recorded for Brussels National Dan and found two.. can't recall what level it was at but it was low. File name associated was AP949130.bgl in Scenery\EurW. I found another copy from a previous install and overwrote mine but it had no effect. Not sure where the second one came from. Turning Autogen from Sparse to None is a bit drastic but its removed the trees!

ATB

DaveB :tab:

DanKH · Post by **DanKH** » 18 Jan 2007, 20:41

The AP-one would be the default one.... as long as the other one there should be no problem with that....well not necessarily... (please note the spelling here...)

Post by **DaveB** » 18 Jan 2007, 22:03

I've just checked again Dan and found only one file associated with EBBR.. the original (although it appears to be modified being shown as MOD). I turned Autogen up to Sparse and the trees appeared again :roll:

Never mind.. its just as easy not to fly there :huf:

ATB

DaveB :tab: