Page 1 of 1

DM Trident in FSX

Posted: 23 Oct 2015, 17:30
by adysmith
I flew this aircraft with some success in FS9, but as my PC has progressed to FSX I decided to install it and give it a go.

I have three problems:-

1) Where is the Pitot Heat switch?
2) I can't raise or lower the gear
3) I can't raise or lower the flaps.

Any ideas?

Re: DM Trident in FSX

Posted: 23 Oct 2015, 18:08
by Effoh
Ady,

Can't think re 1 off the top of my head, but gear and flaps work fine for me in FSX using the default keystrokes.

*edit* pitot is on the overhead at the left http://www.dmflightsim.co.uk/html/Tride ... al_OHP.htm

Re: DM Trident in FSX

Posted: 23 Oct 2015, 18:22
by adysmith
Yep, found the pitot heat, but it is as if I have got no hydraulics.

Yoke buttons don't work, default keystrokes don't work.

Re: DM Trident in FSX

Posted: 23 Oct 2015, 18:35
by Vc Ten
Hi Ade :hello: Don't think you can turn the hydraulics on or off on the trident. Just make sure the default start up a/c in fsx has them switched on, if it has hydraulics that is
Atb
Dale

Re: DM Trident in FSX

Posted: 23 Oct 2015, 22:47
by petermcleland
There are three big Hydraulic system levers in the roof panel...Like everything in the Trident it is "Triplex" :)

Re: DM Trident in FSX

Posted: 24 Oct 2015, 07:57
by adysmith
I thought they were down low by the F/E from my assorted jump seat rides on Tridents :agree:

Re: DM Trident in FSX

Posted: 24 Oct 2015, 08:17
by PaulC
I reistalled the Tridents into FSX yesterday following the "Installing DM's aircraft into FSX" post.
It works perfectly for me.
I'm not sure where you might be going wrong.

Paul

Re: DM Trident in FSX

Posted: 24 Oct 2015, 08:30
by Vc Ten
petermcleland wrote:There are three big Hydraulic system levers in the roof panel...Like everything in the Trident it is "Triplex" :)
Quite right Peter, but they aren't animated, well not on my system :lol:
Atb
Dale

Re: DM Trident in FSX

Posted: 24 Oct 2015, 08:37
by adysmith
Vc Ten wrote:Hi Ade :hello: Don't think you can turn the hydraulics on or off on the trident. Just make sure the default start up a/c in fsx has them switched on, if it has hydraulics that is
Atb
Dale
That looks like it was the problem, I had just flown the RJ100 before, and part of parking chacklist is to power off the hydraulics, which I did, so when I loaded up the Trident there was no hydraulic power.

Restarted FSX this morning and I have flaps and gear :)

Re: DM Trident in FSX

Posted: 24 Oct 2015, 13:24
by Vc Ten
Just as a matter of interest, after shutting down the 1-11 in Dubrovnik this morning, I swapped over to trident 3 where the hydraulics were functional even with the engines and apu off :dunno:
Dale