FS9 FSUIPC progamming
Posted: 09 Jun 2015, 22:31
Anyone? I can do this no trouble in FSX, but the following in FS2004 seems problematic. I have 2 x Saitek throttle quadrants. And wish to program them thru' FSUIPC thusly
from
left hand side are A) throttle 1 & 3 : B) Throttles 2 & 4
Middle two C) Props 1 & 3 D) Props 2 & 4
Right hand p air E) Mixture 1 & 3 F) Mixture 2 & 4
I program in A & B fine
then C & D and it knocks out B
retry to program B and it knocks out C & D
E & F program in OK it is just C&D in conjunction with B that will not take.
I hope that is clear (as mud they all holler). As I say the exact same method works fine in FSX, FSXSE & P3D. cripes what a lot of MSFS based sims I have here
I hardly use P3D (it crashes all the time) or FSXSE (that was future-proofing) and I like FS9 for some of the older a/c and Russian a/c which do not sit comfortably in FSX.
from
left hand side are A) throttle 1 & 3 : B) Throttles 2 & 4
Middle two C) Props 1 & 3 D) Props 2 & 4
Right hand p air E) Mixture 1 & 3 F) Mixture 2 & 4
I program in A & B fine
then C & D and it knocks out B
retry to program B and it knocks out C & D
E & F program in OK it is just C&D in conjunction with B that will not take.
I hope that is clear (as mud they all holler). As I say the exact same method works fine in FSX, FSXSE & P3D. cripes what a lot of MSFS based sims I have here
I hardly use P3D (it crashes all the time) or FSXSE (that was future-proofing) and I like FS9 for some of the older a/c and Russian a/c which do not sit comfortably in FSX.