Page 1 of 1
New FSX T-6G Texan
Posted: 18 Feb 2010, 10:23
by Flying_Junk
Apologies if someone has beaten me to it, but this has been out for a day or two now from Warwick Carter, David Eckert and friends
http://www.flightsim.com/kdl.php?fid=143742. It's a great looking model, flies nicely and is very frame-rate friendly. It comes with two colour schemes and what looks like a paint kit. There are some nice touches, for example you must open the canopy by hand (alright, by mouse) and you have to at least turn on the fuel and ignition before you hit Ctrl+E. This is true freeware, with donations neither expected nor solicited, but who could resist a thank-you for something this good?


Re: New FSX T-6G Texan
Posted: 20 Feb 2010, 12:26
by J0hn
Looks nice - thanks.
DLing now.
J.
Re: New FSX T-6G Texan
Posted: 21 Feb 2010, 23:07
by Trev Clark
This is a wonderful aircraft, really let down by the shortage of a manual! It would have taken an hour to sort one out, just a note-pad read-me for an aircraft that does not start up simply is a really odd mistake, for such experienced developers.
I got quite cross actually trying to start it, it is a dark cockpit and I could not find the magnetos for some time!!! I still cannot find the 'res' fuel tank selector as in the read me, a screenshot with labels is sorely needed to enjoy this to the full.
Re: New FSX T-6G Texan
Posted: 21 Feb 2010, 23:30
by Ferror
Just for you Trev:
The fuel switch is on the left side of the cockpit, behind the elevator trim and the wobble pump; set this to 'res on'.
Now use the wobble pump (Red lever labelled 'Fuel' next to the elevator trim) until the fuel pressure gauge reads between 2 and 3:
Turn the magneto switch to both:
Next push the engine primer three times (For a cold engine):
Now push and hold the starter button on the right console until the engine runs. Due to the head latency of FsX this is a bit tricky but if you zoom in a bit it's easier.
Now go and fly!
Re: New FSX T-6G Texan
Posted: 22 Feb 2010, 12:32
by Trev Clark
Thanks for that, why did the creators not do a similar thing?
I can now see my confusion, the fuel selector 'tool tip' (which I was going by) does not say
'res' but
'2nd Center' ! I will now try to get it started, thanks again!!!!
Re: New FSX T-6G Texan
Posted: 26 Feb 2010, 18:12
by DispatchDragon
Although its NOT a Harvard per se - Mike Barnes has left four very nice repaints of this beastie over at
http://www.classicbritishfiles.com.
it really is a jewel
Oh yes Trev -- It helps having the likes of T6Flyer around to help out with the panel
Leif
Re: New FSX T-6G Texan
Posted: 25 Mar 2010, 13:16
by Fodda
Oooooh... This one looks pretty good as well.