Page 1 of 1
Out with the new in with the old
Posted: 15 Oct 2007, 14:04
by VEGAS
Just taken the mighty Brabazon for a test flight departing Filton (naturally!) and headed out over the Severn towards the Bristol channel into the welsh valleys and back again. What a lovely old girl she is. Well done Jens.
Old vs New on the ground at Filton
Heading out over the severn and the monster bridge
How many folks on the ground would be looking up in amazement at her?

Re: Out with the new in with the old
Posted: 15 Oct 2007, 15:05
by DaveB
I certainly would if I couldn't see any prop textures Eddie :o
Nice shots anyway ;-)
ATB
DaveB :tab:
Re: Out with the new in with the old
Posted: 15 Oct 2007, 15:14
by Garry Russell
Hmmmmmm
Prop textures OK in FS.9 :roll:
Garry
Re: Out with the new in with the old
Posted: 15 Oct 2007, 15:32
by TSR2
Its the old FSDS prop texture issue that we've seen before with some of Rick's early betas. The cloud textures are drawn in front of rotors and props etc in FSX.

Re: Out with the new in with the old
Posted: 15 Oct 2007, 15:35
by DaveB
Ah.. rgr that Ben. I have to say that the last shot (nose on) looks a treat.. would have been great as a jet ;-) On the other hand.. those puny prop shafts look.. (I'll leave you to fill in the necessary rude word)
ATB
DaveB :tab:
Re: Out with the new in with the old
Posted: 15 Oct 2007, 16:05
by Techy111
Re: Out with the new in with the old
Posted: 15 Oct 2007, 16:10
by Garry Russell
That what surprised me about the FS.X issue as there is an FS.X version here where as on Rick Stuff there isn't :think: .
Mybe some system setups inter act
Garry
Re: Out with the new in with the old
Posted: 15 Oct 2007, 16:11
by Techy111
Just added a third photo and ....yes the problem is there?
Tony
Re: Out with the new in with the old
Posted: 15 Oct 2007, 17:16
by VEGAS
DaveB wrote:I certainly would if I couldn't see any prop textures Eddie :o
Nice shots anyway ;-)
ATB
DaveB :tab:
Well spotted Dave. Its not just the Brabazon that has an issue with prop textures. Most of the Aircraft within FSX that have props display the same problem when seen against a cloudy backdrop.(as Ben stated) I think the problem stems from GenX. :think: