Classic British Flight Sim

I seem to be encountering a problem with adjusting the ADF frequency on David M's VC10 C1K. It's a while since I last flew this aircraft, so a few days ago I did a fresh download and install. I find I cannot adjust the decimals of either the ADF1 or ADF2 (hundreds and units are fine). The 'click spot' appears to be there, but nothing happens when I click. I don't have this problem with the civil VC10 (or any of David's other aircraft). I can't see any obvious explanation in the manual. Just to be on the safe side, I did another download and install, but with the same outcome.

Am I missing something very straightforward? I would be grateful for some advice from one of the experts.

Regards,
Andrew

Hi Andrew

Yes, I checked and was getting that too.
That's been broke since December then. :redface:
I don't use the C1K much these days.

It was an easy fix & so if you want to download it again it should then work for you.
Make sure that the page lists the download file as VC10_C1K_PANEL_20070801.zip (updated 01Aug07)
If not, refresh the page until it does.
http://www.dmflightsim.co.uk/vickers_vc10.htm

That ADF problem will only affect people that have downloaded the C1K panel since December.

Cheers
David

Thanks, David.

Duly downloaded and working fine. Thanks for the lightning fast response!

Regards,
Andrew