Page 1 of 1
FS Tutorials
Posted: 21 May 2007, 18:11
by auster
I wonder if someone could kindly point me in the right direction to any tutorials that deal with the design of brackets, fork ends, fittings, etc., preferably using FSDSV3. Thanks
Posted: 21 May 2007, 18:23
by DispatchDragon
Look directly above you in the Forum mate
there are more tutorial links than you can shake a stick at
BTW - if your going that way - I'll take a nice J1N GAIGT I think :roll:
Leif
Posted: 21 May 2007, 18:25
by auster
Leif, I've been through that lot and maybe it's my eyesight but I didn't find what I am looking for. Ralph
Posted: 21 May 2007, 21:06
by Rick Piper
Posted: 23 May 2007, 23:19
by auster
Hello Rick, Many thanks for the link. I know that it was included in the sticky at the top of this section, mentioned also by Leif. I can just about manage to produce some brackets, cleats, fork ends, etc. but I feel that there maybe better ways than how I am doing it. Sledgehammer and walnuts come to mind.
Must pay you the highest compliments on your work. Real aircraft design was never as hard as this.
Ralph
Posted: 23 May 2007, 23:23
by Rick Piper
Hi Ralph
No problem Mate.
Sadly Graham Oxtoby (FSPlaza) guy has not been around for the last few months.
I think he had some real life stuff to sort out as he was building up a really good selection of stuff for FSDS 2 & 3 on there.
He is also one of the FSDS beta team along with about 5 others including me
Anyway no worries.
Regards
Rick
