Page 5 of 5
Re: Standby Error
Posted: 31 Aug 2010, 23:06
by nigelb
I don't know why your DVD RW does not show up if it is working. My CD-ROM shows up but the floppy drive (drive A) doe not, even though it works. Strange!
Nigel²
Re: Standby Error
Posted: 31 Aug 2010, 23:25
by Garry Russell
The floppy's not showing either

Re: Standby Error
Posted: 01 Sep 2010, 23:57
by nigelb
What shows in Device Manager? Control Panel - Performance & Maintenance - System - Hardware tab - Device Manager. The floppy drive should be there and your DVD units in the DVD/CD Rom list (click the + to expand).
Nigel²
Re: Standby Error
Posted: 02 Sep 2010, 06:36
by Garry Russell
Hi Nigel
All three show up there

Re: Standby Error
Posted: 02 Sep 2010, 23:05
by nigelb
In that case, right click the dvd drive that is not working and select Properties and see what it says in the box. If it does not say this device is working properly, you can try the troubleshooting procedure, although sometimes that is not much help.
You could also try to uninstall the device from the right click menu. If everything is ok, Windows should find it again after a reboot (plug and play) and install drivers for it. They probably will be generic windows drivers but they may work just fine. You may want to set a manual system restore point before trying the preceeding remedy.
Nigel²
Re: Standby Error
Posted: 02 Sep 2010, 23:29
by Garry Russell
Hi Nigel
Thanks
It's late here now so I'll take a look at that tomorrow

Re: Standby Error
Posted: 08 Sep 2010, 19:08
by nigelb
Gary, I found this article in a newsletter that I subscribe to.
How do I get my attached drive to show in Windows Explorer?
It maybe of some help, although the situation addressed applies to a hard disk rather than a DVD drive.
nigel²
Re: Standby Error
Posted: 08 Sep 2010, 20:56
by Garry Russell
Thanks Nigel
I'll take a look over the next day or so
